The combination of values and selections you have input result in coffers that are smaller than the minimum allowable size for Length (C) and/or Width (D) using this software application.
The sizing parameters for the Coffers of any configuration are as follows:
When Using ALL Classic Intersections, Tees & Corners:
• Coffers may not be less than 12” in the resulting Length (C) and/or Width (D)
When Using Classic Intersections with Geometric Tees OR Geometric Corners:
• Coffers may not be less than 24” in the resulting Length (C) and/or Width (D)
When Using Classic Intersections with Geometric Tees AND Geometric Corners:
• Coffers may not be less than 36” in the resulting Length (C) and/or Width (D)
When Using ALL Geometric Intersections, Tees & Corners:
• Coffers may not be less than 36” in the resulting Length (C) and/or Width (D)
When Using Geometric Intersections with Classic Tees OR Classic Corners:
• Coffers may not be less than 36” in the resulting Length (C) and/or Width (D)
When Using Geometric Intersections with Classic Tees AND Classic Corners:
• Coffers may not be less than 24” in the resulting Length (C) and/or Width (D)
Please try one or more of the following adjustments in order for your Tilton Shallow-Beam Ceiling System design to meet the above mentioned requirements:
1. Decrease the number of Coffers in Length and/or Width
2. Increase the Length (A) and/or Width (B) of the Ceiling
3. Decrease the Width of the Perimeter Molding
Note:
If your project requires coffer sizing which is smaller than what can be configured using this software please submit a Quote Request Form or Contact Us by Email or Phone to allow us to create a configuration that will suit your needs or to provide you with some alternatives.
